|
|
| Simply the fastest most
reliable High-End backup solution available! |
Striper 3 |
|
|
 |
Designed for Host Systems with SCSI
HVD Interfaces/Drives with SCSI LVD/SE Interfaces |
|
| Full
40 MB/sec sustained data throughput |
|
| Increased Performance
– data is striped across five
independent parallel array channels. Data transfer rate, as well as search speed, is
increased by as much as four times the speed of a single tape drive. |
|
|
| Increase
Data Availability – parity information stored
on a parity drive is used to recover data if a tape
containing data cannot be read. Read and write
operations continue in the event of a drive or media
failure. |
|
| Data Reconstruction –
recreates data previously written to a failed drive or
bad media. |
|
| Data
Scrambling – a high speed programmable switch
matrix allows the insertion of the "stripe set
tape cartridges" in any order for ease of tape
management. |
|
| Graphical User Interface
– the GUI (Optional) incorporates full, on-line and
off-line controller configuration and diagnostics under
Wind95 and NT operating systems.. |
|
| Plug
Compatibility – The tape array controller is
presented to the host as a single SCSI tape drive
providing "plug and play" with host systems supporting
SCSI-1 and SCSI-2 tape protocols. |
|
| Robotics
Support – compatible with existing autoloader
and library software in both striping and mirroring
modes of operation. |
|
|
| Operating Modes Include: |
|
| Data Striping – across 2
or 4 drives with or
without an additional parity drive. Data transfer rate is increased by a factor of
two or four respectively. |
|
| Mirroring – simplifies
Disaster Recovery Plans by writing the
"data" to up to five separate drives simultaneously. |
|
| Pass-thru – allows direct accessing of individual
drives within the array. |
|
| Offline Copy, Copy/Verify and
Verification Only
– provides high speed media duplication and
verification operations initiated from the GUI or
front panel without host system intervention. |
|
| Offline Diagnostics
– performs drive read and write tests initiated
from the GUI or front panel. |
|
|
| Target Markets |
|
|
 |
Disaster Recovery |
|
|
|
High Speed
Backup/Restore |
|
|
|
Video Streaming |
|
|
|
Data Acquisition |
|
|
|
Defense |
|
|
|
Financial |
|
|
|
Government |
|
|
|
Imaging |
|
|
|
|
|
|
| Supported RAID Levels |
| Level 0 |
Striping
two drives (2+0) or four drives (4 + 0) |
|
Level 3 |
Striping two drives or four drives plus a parity drive
(2+1 or 4 +1) |
|
Level 1 |
Mirroring two, three, four, or five drives |
|
|
| Ease of Use |
- Flash Upgradeable
- No Special Software Drivers
- Compatible with all major operating systems
(Workstations, Servers & Mainframes)
- Requires a single SCSI ID
- Plug and Play via SCSI cable, self-diagnostics and
menu driven front panel
- 5 1/4" form factor
- Optional rackmount and 5 1/4" enclosures
available
|
|
| Host Interface |
| High Voltage Differential (HVD) Interface -
The host interface provides connection between
the array controller and the SCSI host system.
It conforms to the SCSI-3 protocol while maintaining
compatibility with SCSI-1 and SCSI-2, 8/16 bit SCSI. Fast
ULTRA synchronous
transfers combined with wide transfers allows for a
maximum of 40 MB/sec sustained data transfer rate. |
|
| Array Interface |
| Single-Ended (SE) Interface -
The array interface provides interconnection between the
array controller and SCSI tape drives. It consists
of five independent parallel wide SCSI channels, up to
four channels are used for data and 1 channel is
optionally used for parity, 8/16 bit SCSI. The
fast synchronous
transfers combined with wide transfers allows for a
maximum of 20 MB/sec sustained data transfer rate. Compatible with all SCSI-1,
SCSI-2 and SCSI-3 tape drives including 4mm, 8mm, VHS,
Reel/Reel, 3480, AIT, DLT, SDLT, LTO and IBM 3480/3490/3590. |
|
| Operator Console |
| The front panel operator console features a 4
line by 20 character display and 4 push button key pad. |
|
|
|
|
| T103 |
|
Controller board only |
|
|
|
| T803 |
|
5 1/4" Half
Height internal packaging with front panel operator console |
|
|
|
| T1003 |
|
Table Top external
packaging with power supply and front panel operator console |
|
|
|
| T2103 |
|
Single Controller
Board, 1U high 19 inch rackmount with power supply and front panel operator console |
|
|
|
| T2203 |
|
Dual Controller
Boards,1U high 19 inch rackmount with 2 power supplies and 2 front panel operator consoles |
|
|
|
|
|
One Year Warranty |
|
|
| Width |
Depth |
Height |
|
|
|
|
|
| Board |
|
5.50" |
7.80" |
0.50" |
| 5 1/4" Half
Height |
|
5.75" |
9.20" |
1.67" |
| Low Profile Table
Top |
|
9.75" |
11.00" |
2.50" |
| Rackmount |
|
17.00" |
23.31" |
1.75" |
|
| Environment (Exclusive of Drives) |
|
| POWER |
|
|
| Input Voltage |
|
+5VDC,
10% |
| Supply Current |
|
3.5
amps, max |
|
|
| TEMPERATURE |
|
| Operating |
|
5
degree C to 50 degree C |
| Non-operating |
|
-40
degree C to 60 degree C |
|
|
| HUMIDITY |
|
| Operating |
|
10% to
80% non-condensing |
| Non-operating |
|
10% to
90% non-condensing |
|
|
Also available as:
|
|
|
|
Library Master
Specifications
|
|
RAIL
Master Specifications
|
|
|
|
|
|
LibraryMaster™
Models
|
|
|
|
| TL103 |
|
Controller board only |
|
|
|
| TL803 |
|
5 1/4" Half
Height internal packaging with front panel operator console |
|
|
|
| TL1003 |
|
Table Top external
packaging with power supply and front panel operator console |
|
|
|
| TL2103 |
|
Single Controller
Board, 1U high 19 inch rackmount with power supply and front panel operator console |
|
|
|
| TL2203 |
|
Dual Controller
Boards,1U high 19 inch rackmount with 2 power supplies and 2 front panel operator consoles |
|
|
|
RAILMaster™
Models
|
|
|
|
| TR103 |
|
Controller board only |
|
|
|
| TR803 |
|
5 1/4" Half
Height internal packaging with front panel operator console |
|
|
|
| TR1003 |
|
Table Top external
packaging with power supply and front panel operator console |
|
|
|
| TR2103 |
|
Single Controller
Board, 1U high 19 inch rackmount with power supply and front panel operator console |
|
|
|
| TR2203 |
|
Dual Controller
Boards,1U high 19 inch rackmount with 2 power supplies and 2 front panel operator consoles |
|
|
|
|
|
 |
 |
 |
5
1/4" Internal
Half Height |
Low
Profile
Table
Top |
Rackmount |
|
|
 |
Ultera Systems, Inc.
26052 Merit Circle · Laguna Hills, CA 92653
Phone: 949.367.8800 · Fax: 949.367.0758
E-mail: inform@ultera.com
Visit us at www.ultera.com |
|
