Contact Ultera at (949)-367-8800
    USA  
bannertest.gif (7122 bytes)
corner.gif (613 bytes)







Where to Buy
About Ultera
FAQs
Articles
Feed Back
Press
Careers
Home
 

 Models

  Imager 3
  LibraryMaster
  RAILMaster
 Related
  S-Imager
  Imager 1
  Imager 2
  Imager 3
  ShadowMaster
Contact us to configure an Ultera solution to fit your needs
      Imager 3      Tape RAID Controller   
Tape Mirroring
dot.gif (941 bytes) High Performance
dot.gif (941 bytes) Enhanced Reliability
dot.gif (941 bytes) Disaster Recovery

When One Copy Just Isn't Enough
Increased Overall System Performance – Simultaneously create two identical backup tapes in real-time.  No additional software overhead.
Half Height
TableTop Enclosure
*Also available as SCSI High Voltage Differential (HVD)
Increased Data Availability – Recover valuable data even if one tape becomes lost, stolen or damaged.
Increased Reliability – Either copy can be used independently for recovery.
Robotics Support – Mirrors within a single tape library (LibraryMaster™) or across two tape libraries (RAILMaster™).
Disaster Recovery – Automatically backs up data to 2 tapes.  Restores data from one tape allowing mirror copy to be taken offsite.
100% Software Transparency – No software changes of any kind are required.  For current systems using tape, the imager 3 is plug and play with "ALL" existing tape backup software.
Windows 2000/NT GUI – An optional full featured GUI for controlling and monitoring all operating and off-line modes.
Plug Compatibility – The Imager 3 controller is presented to the host as a single SCSI tape drive or tape library providing plug and play with host systems supporting SCSI-1 and SCSI-2 tape protocols.
Offline Operations – The Imager 3 controller has built in hardware utilities for: Tape Copy, Tape Compare, Tape Verify, Tape Drive Diagnostics and "Self Test" Diagnostics.
      Imager 3      

Specifications             

Supported RAID Levels
Level 1 Mirroring two drives, Autoloaders or Libraries
Host Interface 
Low Voltage Differential/Single-Ended (LVD/SE) - The host interface provides connection between the Imager 3 mirroring controller and the SCSI host system. It conforms to the SCSI-3 protocol while maintaining compatibility to SCSI-1 and SCSI 2, 8/16 bit SCSI.  Ultra2 LVD Wide synchronous transfer provides 80 MB/sec burst data transfer rate.  
Array Interface 
Low Voltage Differential/Single-Ended (LVD/SE) - The drive interface provides two parallel SCSI channels between the Imager 3 mirroring controller and the tape drives. The 8/16 bit Ultra SCSI Fast synchronous transfers combined with wide transfers allows for maximum of 40 MB/sec burst data rate. Compatible with SCSI-1, SCSI-2 and SCSI-3 devices. ALL major tape drives are supported. All major tape drives are supported including 4mm, 8mm, VHS, Reel/Reel, 3480, AIT, DLT, SDLT, LTO and IBM 3480/3490/3590.
GUI for Windows 2000/NT
Ultera offers an optional remote access Graphical User Interface program called Ultimate that runs under Windows 2000/NT. Running on the host system, Ultimate allows the user to  remotely control and monitor up to 8 Ultera Tape Array subsystems.
Operator Console
The front panel operator console features a 4 line by 20 character display and 4 push button key pad.
  Imager 3 Models
TM052 Controller board only
TM852 5 1/4" Half Height internal packaging with front panel operator console
TM1052 Table Top external packaging with power supply and front panel operator console
TM2152 Single Controller Board, 1U high 19 inch rackmount with power supply and front panel operator console
TM2252 Dual Controller Boards,1U high 19 inch rackmount with 2 power supplies and 2 front panel operator consoles
One Year Warranty
  Dimensions Width Depth Height
Board 5.50" 7.80" 0.50"
5 1/4" Half Height 5.75" 9.20" 1.67"
Low Profile Table Top 9.75" 11.00" 2.50"
Rackmount 17.00" 24.00" 1.75"
Environment (Exclusive of Drives)
POWER
Input Voltage +5VDC, 10%
Supply Current 3.5 amps, max
TEMPERATURE
Operating 5 degree C to 50 degree C
Non-operating -40 degree C to 60 degree C
HUMIDITY
Operating 10% to 80% non-condensing
Non-operating 10% to 90% non-condensing
Also Available As:

 

Library Master Specifications
RAIL Master Specifications

 LibraryMaster™ Models

TL052 Controller board only
TL852 5 1/4" Half Height internal packaging with front panel operator console
TL1052 Table Top external packaging with power supply and front panel operator console
TL2152 Single Controller Board, 1U high 19 inch rackmount with power supply and front panel operator console
TL2252 Dual Controller Boards,1U high 19 inch rackmount with 2 power supplies and 2 front panel operator consoles

 RAILMaster™ Models

TR052 Controller board only
TR852 5 1/4" Half Height internal packaging with front panel operator console
TR1052 Table Top external packaging with power supply and front panel operator console
TR2152 Single Controller Board, 1U high 19 inch rackmount with power supply and front panel operator console
TR2252 Dual Controller Boards,1U high 19 inch rackmount with 2 power supplies and 2 front panel operator consoles
Half Height
TableTop Enclosure
Dual Controller 1U Rackmount
5 1/4" Internal
Half Height
Low Profile
Table Top
Rackmount
          UltNewLogo.GIF (3212 bytes)

Ultera Systems, Inc.
26052 Merit Circle · Laguna Hills, CA 92653
Phone: 949.367.8800 · Fax: 949.367.0758
E-mail: inform@ultera.com
Visit us at www.ultera.com

© 1994-2003. Ultera Systems, Inc. All Rights Reserved., Legal Information
| Site Map | Ultera Solutions | High Performance | Disaster Recovery | Data Archiving | Media Duplication | Video Streaming | CD-R Mastering | DVD-R Mastering | Ultera Products | Tape RAID Controller | Tape Striping | Tape Mirroring | Tape Library Striping | Tape Library Mirroring | Optical RAID Controller  | Optical Striping | Optical Mirroring | Optical Library Striping | Optical Library Mirroring  | Remote ManagementWhere to Buy  | About Ultera | FAQ | ArticlesFeedback | Press | Careers | Home |